|
Size
220 mm x 95mm x 45mm
Weight
500g (not including accelerometer)
Environmental
Water: MIL-STD-810F, Method 512.4
IP67 sealed against accidental immersion
(1m for 30 min)
Drop: MIL-STD-810F, Method 516.5, Procedure IV
26 drops from 1.22 m
6 additional drops at –20º
6 additional drops at 60º
Operating: -30º to 65º
Storage: -40º to 70º
Humidity: MIL-STD-810F, Method 507.4
Sand & Dust: IP67, MIL-STD-810F, Method 510.4,
Procedures I & II
Power supply
Rechargeable battery (charger included)
Battery life
Typically 20 hours operating time depending on backlight usage.
Frequency range
10 Hz to 1 kHz (or 15kHz)
Frequency resolution
1.3 Hz (or 18.75 Hz)
800 lines FFT
Displayed Amplitude Units
Acceleration in g
Velocity in mm/s ( or inches/s)Bearing noise in BDU (bearing damage units)
Displayed Frequency Units
Hertz (Hz), RPM or CPM
Input range
+/- 50g with standard 25mV/g C-Cubed
accelerometer
Dynamic range
120 dB +/- 50g to +/- 0.0004g with standard accelerometer
Auto set up of VA
diagnostic bands
(RPM = run speed)
Instability 10Hz - 0.75 x RPM
Unbalance 0.75 x RPM - 1.5 x RPM
Alignment 1.5 x RPM - 2.5 x RPM
Looseness 2.5 x RPM - 3.5 x RPM
Accelerometer
Connection
Standard 10 pin IP67 connected smart
accelerometer with built-in ID and sensitivity
calibration (nominally 25mV/g)
Keypad or Touch
screen operation
Stylus free collection of vibration data using single key press or touching screen
Options
• Carrying case with neck strap
• Stylus lanyard
• Docking station
|
